Glass door installation method

Glass door installation method

<a target='_blank' href=''><strong>Glass door installation method</strong></a>.jpg

1. Pay-off positioning: the glass door composed of fixed glass and movable glass door leaf is unified for pay-off positioning.

2. Limit slot at the top of the installation frame: The width of the limit slot should be greater than the glass thickness of 2-4mm, and the slot depth is 10-20mm. When installing, first draw two edges of the metal decorative plate from the center line, and then install the limit groove on the top of the door frame according to the edges.

3. Install wood veneer with metal veneer: first fix the square wood to the ground, and then use universal glue to glue the metal veneer to the wood The method of connection is fixed.

4. Install vertical door frame: nail the frame of the door frame with the centerline of the bullet, then use plywood to determine the shape and position of the door frame column, and finally wrap the metal decorative surface.

5. Glass installation: Use a glass suction cup machine to suck the thick glass, and then hold the suction cup handle to lift the thick glass plate by 2-3 people and move it to the installation position.

6. Fixing the glass: nail two small square wooden strips inside and outside on the bottom bracket to clamp the thick glass in the middle door, the square wooden strip is about 4mm away from the glass panel surface, and then apply the universal glue on the square wooden strip. The facing metal is stuck on the square bar.

7. Glass-filled plastic seal: Inject into glass-filled seals on both sides of the top limit slot and bottom bracket slot, as well as the gap between the thick glass and the frame column.

8. Butt joint between glass: When the fixed part of the glass door needs to splice the glass due to the large size, the seam should have a width of 2-3mm, and the edge of the glass plate should be chamfered.

9. Installation of moving glass door leaf: Before the door leaf is installed, the positioning pin of the ground floor spring and the top surface of the door frame should be positioned and installed. The two must be coaxial, check with a hanging vertical line during installation to ensure that the rotation axis of the floor spring and the center of the positioning pin The lines are on the same straight line.

10. Install upper and lower glass door leaf clips: Install the upper and lower metal door clips on the upper and lower ends of the glass door leaf respectively, and measure the height of the door leaf.

Jiangmen Jiangyi Industrial Co., Ltd.committed to the production of glass deep-processing tools & glass hardware and import and export trade, enjoying a good reputation in this industry.


TEL.:0086-750-3876831,3876811 Contact Person:MAPLE


FAX.:0086-750-3876838 SKYPE: JIANGYI_MAPLE